For entry-level enthusiasts, DJI now brings out the most cost-effective solution, the NAZA-M Lite flight control system. As the simplified version of NAZA-M, it inherits the high reliability and stability of NAZA-M. The innovative All-in-one design simplifies installation and saves space and weight. It contains inner damping, controllers, 3-axis gyroscope, 3-axis accelerometer and barometer in its light and small Main Controller. It can measure flying altitude, attitude and therefore can be used for autopilot/automatic control.

FUNCTIONS

• Manual Mode;
• Atti. Mode;
• GPS Atti. Mode;
• Intelligent Orientation Control(IOC)：Course lock/Home lock
• Enhanced Fail-Safe：Landing / Go Home & Landing;
• Quad-rotor I, X; Hex-rotor I, V; Y, IY;
• Combination Stick Command to start; Immediately Mode and Intelligent Mode to stop;
• Remote gain tuning;
• Two-axis gimbal supported, Multi Gimbal Servo Output Frequency Supported;
• Support Normal receiver, D-Bus Port support S-bus and PPM receiver;
• Voltage Monitor and Low Voltage Protection;
• 4 channels transmitter support;
• Five-level Motor Idle Speed adjustable in Motor Mixer;
• IMU Calibration function;

NOTICES

• For safety reasons, do not use power battery during firmware upgrade.
• Make sure you reconfigure all parameters after upgrading firmware.

Click Here For More Information About Naza-M Lite.